Wireless usage 무선으로 사용

Wi-Fi를 통해서 단말을 adb 접속시키는 방법

  1. Connect your Android device and adb host computer to a common Wi-Fi network accessible to both. We have found that not all access points are suitable; you may need to use an access point whose firewall is configured properly to support adb.

    Note: If you are attempting to connect to a Wear device, force it to connect to Wi-Fi by shutting off Bluetooth on the phone connected to it.

  2. Connect the device to the host computer with a USB cable. USB 케이블을 사용해서 디바이스와 컴퓨터 연결
  3. Set the target device to listen for a TCP/IP connection on port 5555. 타켓 디바이스를 포트 5555를 통해 TCP/IP 접속하도록 세팅

    $ adb tcpip 5555
  4. Disconnect the USB cable from the target device. USB 케이블 접속을 해제
  5. Find the IP address of the Android device. For example, on a Nexus device, you can find the IP address at Settings >About tablet (or About phone) > Status > IP address. Or, on an Android Wear device, you can find the IP address atSettings > Wi-Fi Settings > Advanced > IP address. 안드로드의 IP 주소 확인 방법
  6. Connect to the device, identifying it by IP address. 디바이스 IP 주소를 입력하여 디바이스 연결

    $ adb connect <device-ip-address>
  7. Confirm that your host computer is connected to the target device 타겟 디바이스가 연결되었는지 확인:

    $ adb devices
    List of devices attached
    <device-ip-address>:5555 device

You're now good to go!

If the adb connection is ever lost 만약 연결이 끊어진다면 :

  1. Make sure that your host is still connected to the same Wi-Fi network your Android device is. 디바이스와 호스트가 동일한 Wi-Fi 사용중인지 확인.
  2. Reconnect by executing the "adb connect" step again. "adb connect" 를 재 실시
  3. Or if that doesn't work, reset your adb host 위 내용 실시에도 연결아 안되는 경우 서버 종료 후 재실시:

    adb kill-server
    and then start over from the beginning.


'Japan > Work As Tester' 카테고리의 다른 글

adb shell 명령어  (0) 2016.03.18
VoLTE관련  (0) 2016.03.18
디바이스와 adb 무선으로 사용하도록 세팅  (0) 2016.03.18
ADB 명령어(1)  (0) 2016.03.18
DDMS(Dalvik Debug Monitoring Service)  (0) 2016.03.18
DUT  (0) 2016.03.09

+ Recent posts